Putting the trigger bar back in place on a Glock Performance Trigger is a real pain. We built this little tool to help.
Instructions:
- Push the trigger spring with sear-holder up.
- Slide the Performance Trigger Tool through the round hole, opposite the side where the trigger bar will slide in.
- Push the trigger spring with sear-holder back down, holding it in place so the spring rod pushes on the slave pin.
- Install the trigger bar, making sure the lower extension/pin sits in the tool's open hole.
- Slide out the Performance Trigger Tool.
Ready to install!
"GLOCK" is a federally registered trademark of GLOCK, Inc. and is one of many trademarks owned by GLOCK, Inc. or GLOCK Ges.m.b.H. Fish Horn Creation is not affiliated in any manner with, or endorsed by, GLOCK, Inc. or GLOCK Ges.m.b.H. Use of "GLOCK" on this page is solely to describe compatibility with Glock parts and components. For genuine GLOCK products, visit www.glock.com.
All information posted here is for informational use only. If you make any modifications to your firearms based on this content, you do so at your own risk. Done incorrectly, this can render a weapon unsafe or unusable.
Questions or requests? Contact us — we're happy to help.
0 comments