Wish you had a 3rd hand to hold your Glock slide while you work on it? Trying to adjust your sights or add an optic? This tool is for you. There are 3 models, one for each slide type/size.
The photos here may show different slide sizes, but the tool functions the same across all of them.
After separating your slide from the frame, slide the block in from the back of the slide. It's a snug fit — you may need to pinch the sides to get it started.
No need to remove any parts from your slide to use it. In most cases you'll want to keep the block toward the back of the slide, where most of the work happens.
The slide tool is made from non-marring plastic softer than the slide itself. Over time it can wear and loosen up — we added a tightening screw for that. As you thread it in, it spreads slightly and holds the slide tighter.
With the barrel and recoil spring removed, the block can be used at any position on the slide.
0 comments